D Scan Mode; Manual Scan - AOR AR7000 Manual

3. Push the [RUN/BRK] key to start the program search process, the LCD displays
the legends "P.SEARCH" (in light blue) and "Run" (in red) to confirm selection.
{figure 19}
Remember, the squelch must be advanced high enough to cancel the background
noise or the search process will not progress as the AR7000 will think that it has
found a busy frequency. Press [SQL] and rotate the main dial clockwise until
background noise in cancelled then press [ENT] to accept the new value.
Resultant frequency spectrum analysis will be displayed on the lower section of the
LCD (in green) as the search process advances. Strong signals appear as high
vertical bars and weak or no signal as low bars. When a signal above the squelch
threshold is received, the search process will stop on the active frequency and you
will hear the transmission (if the volume is high enough) until the busy signal has
disappeared (or in case of time controlled search is selected, after the specified time
has elapsed). Rotate the main dial to force the search onward.
When the search reaches the top frequency limit, the search jumps back to the
lowest frequency limit then advances forward again (depending on setting of forward,
reverse, loop or link in the configuration menu).
4. Push the [RUN/BRK] key while the program search is in progress to stop the
search. The legend "Brk" will be will be displayed in place of "Run" on the LCD.
{figure 20}
You may manually tune around by rotating the main dial, a cursor (vertical dark band
through the spectrum display) follows your movement through the limits of the display
window.
5. Push the [ENT] or [ESC] key to return to the program search menu to make
changes or to select a different search bank.
6. Push the [ESC] key to return to the operating mode before the program search
process began.

D Scan mode

D-1 Manual scan
1. While in the memory mode (press the [ or [ key until "MEMORY" is
displayed) press the [BANK] key. The bank number legend will reverse contrast on
the LCD. Rotate the main dial to select the desired bank number, there are 15 scan
banks numbered 0 to 14, accept the selection by pressing [ENT].
{figure 21}
2. Push the [RUN/BRK] key, the legend "M.SCAN" will appear on the LCD to confirm
selection and the scan process will start.
{figure 22}