Select Scan While In Scan Mode; Select Scan While In Memory Recall - AOR AR8000 Operating Manual

11-1 SELECT SCAN - while in SCAN MODE (tagging and un-tagging)
While the receiver is scanning it will stop on active frequencies and you will
soon decide that some are "interesting" and some "uninteresting".
To build up your select scan list of interesting channels, start to "tag" the
interesting channels while the scan sequence pauses on active memory
channels by pressing [FUNC] [PASS].
A lower case (small) letter "s" will be displayed on second line of the LCD to
the far left with the frequency to the right of the same line.
Each time the sequence [FUNC] [PASS] is keyed then the SELECT SCAN
status "s" is toggled so that the channel may be "tagged" (chosen / registered)
and "un-tagged" at will.
"Tagging" a memory for SELECT SCAN will not force the scan to continue nor
affect the way in which the memory channel or SCAN mode operates at this
time. Simply when the signal disappears normal SCAN mode is resumed.
11-2 SELECT SCAN while in MEMORY RECALL (M.RE) mode (tagging
and un-tagging)
SELECT SCAN channels may be "tagged" or "un-tagged" while in memory
recall mode by first selecting the desired memory channel then press [FUNC]
[PASS].
Press [SCAN] to place the receiver into memory recall mode (M.R). The
legend "M.RE" appears on the top left of the LCD to confirm operation.
The receiver will display a memory channel, mode, frequency and text. You
may now choose and "tag" the memory channels you wish to add to the
SELECT SCAN list from any of the 20 memory banks. Of course, if the
PASSWORD of banks is in force you must first enter you password code to
access the protected banks.
If the desired memory channel is not immediately displayed it may be
RECALLED be keying in the required location.
To recall memory channel "A00" type [1A] [0] [0] there is no need to press
enter.
The "M.RE SELECT" menu automatically appears when the [1A] key is
pressed so that the frequency and comments are displayed on the third and
fourth lines of the LCD for easy recognition.
Alternatively, the [DIAL] may be rotated to review, hunt for and select memory
channels to be "tagged" or "un-tagged" for SELECT SCAN.
When the memory channel has been "tagged" using the sequence [FUNC]
[PASS], a lower case (small) letter "s" will be displayed on second line of the
LCD to the far left with the frequency to the right of the same line.