Installing The Realpresence Collaboration Server 1800; Unpacking The Realpresence Collaboration Server 1800 - Polycom Collaboration Server (RMX) 1800 Hardware Manual

RealPresence Collaboration Server 1800 Hardware Guide
•
•
•
Sealed System! The RealPresence Collaboration Server 1800 is a sealed system, breaking the
seal and opening the chassis VOIDS the WARRANTY!

Installing the RealPresence Collaboration Server 1800

The following procedures have to be performed to install the RealPresence Collaboration
Server 1800 in your site:
•
•
•
•

Unpacking the RealPresence Collaboration Server 1800

To unpack and lift the RealPresence Collaboration Server 1800:
1
2
Write down the system's serial number that is on a sticker on the back of the unit. It will be needed
for product registration later in the process.
Make sure that boxes contain all the required parts.
Polycom, Inc.
Use a regulating uninterruptable power supply (UPS) to protect the RealPresence
Collaboration Server 1800 from power surges and voltage spikes, to keep your MCU
operating in case of a power failure.
Place the RealPresence Collaboration Server 1800 on a hard, flat surface such as a
desktop or mount it on 19" rack.
The airflow of the RealPresence Collaboration Server 1800 is from front to back. Be sure
that the areas in the front and rear side of the system are clear for proper ventilation.
Unpacking the system
Installing the system in a rack or as a standalone system
Connecting the system to the power source
Connecting the network (LAN and IP) cables to the system
When you receive the RealPresence Collaboration Server 1800 packing case, inspect the
equipment for damage and verify that the components match the packing slip.
Open the top cover of the packing case.
Boxes are placed on the top Stratocell® and contain power cables, 2 ethernet cables,
USB key and documentation.
7