Introduction; Maintenance; Handling The Printer - Xante PlateMaker 3 Manual

Introduction

Your PlateMaker 3 printer requires minimal maintenance. This
chapter describes how to handle, store, move, and clean your printer
and contains technical specifications and warranty information.

Maintenance

Proper care will extend your printer's life. Use the guidelines in this
section to maintain your printer in optimum working condition and
to ensure the highest quality output.

Handling the Printer

Use the following guidelines when handling or using your printer.
Warning! The printer weighs approximately 58.5 lbs (26.5 kg)
without toner, cassettes, and media installed. Always
have two people lift the printer, using the recessed grip
areas on the right and left sides only.
• At the end of the day, turn off the printer following the
procedure in chapter 2.
• Never move the printer with the toner cartridge installed.
• Do not place anything on top of the printer.
• Always lift the printer by the recessed grip areas on the
bottom—never by the cartridge slot or multipurpose feeder.
• Only use media that meets printer requirements. See "Media
Specifications" in chapter 7 for details.
• Make sure the printer's location meets the requirements in
"Printer Location" in chapter 2.
• Never oil the printer.
• Allow the printer side vent at least an 8.0" (200 mm) clearance
to prevent overheating. Never insert anything into the vent.
_________________________ Maintenance and Specifications 9-3