Installing The Transformer - Brother LH4-B800E Instruction Manual

4. INSTALLATION

4-11-6. Installing the transformer

The transformer can be installed on the floor, on the work table leg (on top of the leg or on the treadle
support plates) or underneath the work table.
* Check the power supply rating label on the transformer to confirm that the voltage ratings for the
transformer and the control box are identical.
Mounting
bracket
112.5mm
2072Q
(3)
Washer
(3)
2074Q
18
Screw
(M5×8)
(2)
(2)
(1)
(2)
Screw (M6×14)
1) Floor installation
Select a suitable location, and place the transformer
on the floor in that location.
* Select a location where the transformer will not
be an obstruction to people walking past.
2069Q
2) Table leg installation (on top of table leg)
2070Q
Secure the transformer to the top of the table leg
using the mounting bracket and screws.
* The mounting bracket and screws must be obtained
separately.
2071Q
3) Table leg installation (treadle support plates)
2073Q
1. Remove the screws (1), and then remove the
handle (2).
2. Place the transformer onto the two treadle
support plates (3) as shown in the illustration, and
then secure it with the washers and screws.
* The washers and screws must be obtained sepa-
rately.
HE-8000