Control Circuit Board Dip Switches - Brother LH4-B800E Instruction Manual

13. CHANGING FUNCTIONS USING THE DIP SWITCHES

13-2. Control circuit board DIP switches

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from
the wall outlet before opening the face plate of the control box. Touching areas where high voltages
are present can result in severe injury.
(3)
(1)
82
DANGER
1. Remove the six screws (1), and then open the
operator's side cover (2) of the control box.
NOTE:
When opening the cover (2), hold it securely so
that it does not fall down.
2. Change the setting of the DIP switch (3).
• Refer to the DIP switch table for an explana-
tion of the functions of each DIP switch.
3. Close the cover (2) of the control box, and tighten
the six screws (1).
NOTE:
Turn the power off before changing the DIP switch
settings.
If the settings are changed while the power is still
on, they will not take effect.
(2)
2191Q
HE-8000