Thread Breakage Before Sewing Is Finished - Brother LH4-B800E Instruction Manual

8. SEWING

8-1-3. Thread breakage before sewing is finished

Set panel DIP switch A-1 to ON.
Even if sewing is complete, leave the work clamp lowered and check the sewing. Then depress the treadle
backward to trim the thread and raise the work clamp.
If the thread breaks just before sewing is complete, and then sewing is completed without the thread
breakage being detected, the following operations are possible.
1. To finish sewing in this condition
1) Press the RESET key (3).
(The feed mechanism will return to the sewing start position and the work clamp will rise.)
2) Sewing will start again when the treadle is depressed.
2. To continue sewing from around the location of the breakage
1) Press the parameter DOWN key (16) to move to position to continue sewing from.
2) If you do not want the cutter to operate, press the CUTTER ON key (5) to turn off the cutter.
3) Depress the treadle. The rest of the sewing will be carried out.
4) After sewing is complete, depress the treadle. The thread will be trimmed and the work clamp will be
raised.
5) Before carrying out any further sewing, press the CUTTER ON key (5) to turn on the cutter.
3. To sew from the sewing start point without raising the work clamp (without shifting the material)
Re-sewing
1) While pressing the parameter DOWN key (16), press the RESET key (3).
(The feed mechanism will return to the sewing start position, but the work clamp will not rise.)
2) If you do not want the cutter to operate, press the CUTTER ON key (5) to turn off the cutter.
3) Depress the treadle to start sewing.
4) After sewing is complete, depress the treadle. The thread will be trimmed and the work clamp will be
raised.
5) Before carrying out any further sewing, press the CUTTER ON key (5) to turn on the cutter and return
the program number to the previous number.
4. To sew from the sewing start point without raising the work clamp in the next program (without
shifting the material)
1)The next program number can be retrieved when re-sewing.
(For example, if there is a program which has already been assigned to a different program number
which has the same buttonhole shape and which has underlays sewn together as an added function,
then you can retrieve that program.)
Press the Program No. UP key (7) or the Program No. DOWN key (8) to select the program, and then
press the ENTER key (17).
2) If you do not want the cutter to operate, press the CUTTER ON key (5) to turn off the cutter.
(3)
(7)
(8)
(5)
66
Finish
Re-sewing in the next program
(13) (17)
3) Depress the treadle to start sewing.
4) After sewing is complete, depress the treadle.
The thread will be trimmed and the work clamp
will be raised.
5) Before carrying out any further sewing, press the
(14)
CUTTER ON key (5) to turn on the cutter and
return the program number to the previous
(15)
number.
(16)
2156Q
HE-8000
Resuming sewing