Table of Contents
Advertisement
REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and increase your satisfaction
with
your Kenmore dryer.
[
Check that all parts you removed
from the parts packages are now
installed.
[
Ensure that dryer is positioned in
its final location. Make sure vent is
not crushed or kinked.
[
Ensure that dryer is level by placing
a level on top of the dryer, first side-
to-side; then front-to-back,
If dryer is
not level, adjust the legs up or down.
[
Check to make sure you have all
the tools you started with.
FINAL STEPS
[
Plug the power supply cord into the
grounded outlet or connect direct
wire to power supply.
[
Turn power supply on.
[
Wipe the interior of the drum
thoroughly
with a damp cloth to
remove any dust.
V Read the rest of this manual to fully
understand your new dryer. Start the
dryer and allow it to complete a full
heat cycle (not the air cycle). After five
minutes, open dryer door, You should
feel heat inside the dryer. If you do
not feel heat, see Troubleshooting
information
on pages 36-37.
NOTE: You may notice a burning odor.
This smell is common when the heating
element is first used. The smell will
go away.
25
Advertisement
Table of Contents
