Table of Contents
Advertisement
END-OF-CYCLE
SIGNAL CONTROL
SOFT-HEAT ®SYSTEM
Your dryer sounds a signal when
a drying cycle is finished.
The signal is helpful when you are
drying permanent press, synthetics,
and other items. These items should
be removed from the dryer as soon
as it stops in order to prevent wrinkles.
PUSH TO START BUTTON
Use this control to start the dryer. Be sure
the dryer door is closed.
Opening the door stops the dryer. It will
not start again until you close the door
and press the PUSH TO START Sutton,
Be sure the Cycle Selector Control (Timer)
is still on a drying cycle or air setting.
PUSH TO START
SOFT-HEAT ®System guards against
overdrying.
This helps your fabrics
retain the natural moisture they need,
prevents
static, and reduces
pilling
-
the formation
of small lint-like
balls
on the surface of garments.
Pilling is
the natural result or wearing and
washing of garments.
Kenmore dryers help prevent overdrying
so you get outstanding
fabric care. In
the AUTO DRY and TIMED DRY Cycles,
clothes are dried at the temperature
you selected until the last few minutes
of the cycle. The dryer then switches to
low heat.
COOLDOWN
Approximately
ten minutes before the
end of the AUTO DRY and TIMED DRY
Cycles, clothes are tumbled without heat
to help reduce wrinkles and make clothes
more comfortable to handle.
USING WRINKLE GUARD
WRINKLE GUARD helps keep your
permanent
press items wrinkle free
when you cannot unload the dryer
promptly at the end of the AUTO DRY
Cycle.
If you do not open the door at the end of
the AUTO DRY Cycle, WRINKLE GUARD
will tumble the clothes continuously
for
30 minutes.
• This action will continue unless you
open the dryer door.
During WRINKLE
GUARD, the End-of-
Cycle Signal will sound every 5 minutes.
3O
Advertisement
Table of Contents
