Table of Contents
Advertisement
STEP 3. Attach a 3/4-inch, U,L,-listed,
strain relief to the hole below terminal
block opening. Strain relief should have
a tight fit with dryer cabinet and be in a
horizontal position, Put the power supply
cord through the strain relief,
STEP 4. Remove the center terminal
block screw, Remove the neutral ground-
ing wire (green/yellow wire) from external
grounding
screw.
External g round
connector
,c
Center silver-colored
terminal block screw
©
STEP & Connect neutral grounding wire
and the neutral wire (white) of power
supply cord under the center screw of
terminal block.
STEP 6. Connect the other two insulated
wires to outer terminal block screws.
STEP 7. Connect the green, grounding
wire from the power supply cord to the
external grounding conductor screw.
Tighten all terminal block screws firmly.
STEP 8, Tighten the strain relief screws.
STEP 9. Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.
Proceed with Knob Installation.
See "INSTALL
KNOBS" on page 20.
Green/yellow wire
of harness
Center silver-
External
colored terminal
Neutral wire
ground
block screw
(white)
coeeeutor
18
Green wire
Neutral
ofpowersupply
groundingwire
cord or bare
copper wire
3/4_U.L-listed, strain
relief
4-Wire Connection with
Frame-Grounding
Conductor
Advertisement
Table of Contents
