Table of Contents
Advertisement
CHECKING FOR AIR FLOW
OBSTRUCTION
From time to time, you may find it helpful
to check your dryer and exhaust system
for proper air flow. Poor air flow can result
in longer drying times.
To check for air flow obstruction:
STEP 1. Check to ensure nothing is
blocking ventilation slots on dryer rear
panel.
STEP 2. Inspect exhaust hood. It should
not be blocked or obstructed.
REMOVING ACCUMULATED
LINT
Lint can gather inside the exhaust
vent or dryer and be fuel for a fire. Lint
should be removed every 2 to 3 years,
or more often, depending on dryer usage.
Cleaning should be done by a qualified
service person.
To remove accumulated
lint from
exhaust vent:
STEP 1. Disconnect exhaust vent from
the dryer.
STEP 2. Clean one section of vent at a
time until your reach the exhaust hood.
To clean out lint, you can use the hose
attachment
on your vacuum or, use
a pole or wire with a feather duster or
rag attached.
STEP 3. Reconnect vent as described in
the "INSTALLATION
INSTRUCTIONS"
of
this Owner's Manual.
U
To remove accumulated
lint from
inside the dryer:
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all panels before operating.
Failure to follow these instructions
can result in death or electrical
shock,
STEP 1. Unplug the power supply cord
or turn off the electrical power supply.
STEP 2. Remove back panel by removing
the screws along the frame.
STEP 3. Remove lint from the dryer base
with a soft brush or vacuum cleaner. Avoid
damaging wires or electric thermostats.
STEP 4. Replace back panel; reconnect
and level dryer again, if necessary.
MOVING
CARE
• Unplug power supply cord or turn off
electrical power supply.
• Make sure leveling legs are secure in
dryer base.
• Use masking tape to secure dryer door.
VACATION
CARE
• Unplug power supply cord or turn off
electrical power supply.
• Wash lint screen.
35
Advertisement
Table of Contents
