Final Steps - Kenmore 11069912990 Owner's Manual And Installation Instructions

REVIEW INSTALLATION
_WJro_'.,=._reJ._J= ;,I_ a[,_ i"[d
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and increase your satisfaction with
your Kenmore dryer.
[] Check that all parts you removed
from the parts packages are now
installed.
[] Ensure that dryer is positioned in its fi-
nal location. Make sure vent is not
crushed or kinked.
[] Ensure that dryer is level by placing
a level on top of the dryer. Check side-
to-side first, then check front-to-back. If
dryer is not level, adjust the legs up or
down.
[] Check to make sure you have all
the tools you started with.
FINAL STEPS
[] Plug the power supply cord into the
grounded outlet or connect direct
wire to power supply.
[] Turn power supply on.
[] Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining on
dryer.
[] Read the rest of this manual to fully
understand your new dryer.
[] Start the dryer and allow it to
complete a full heat cycle (not the
AIR DRY Cycle). After five minutes,
open dryer door. You should feel
heat inside the dryer. If you do not
feel heat, see "TROUBLESHOOTING".
NOTE: You may notice a burning odor.
This smell is common when the
heating element is first used. The smell
will go away.
29