Domestic Voice Message Reporting; Acknowledging Domestic Voice Message Reporting; Basic Pager Reporting; Basic Pager Display Information - Bosch CC880/LP880, SC8016 Operator's Manual

CC880/LP880, SC8016 | Operators Guide | 26.0
Reporting
26.0 Domestic Voice Message
Reporting
The system can be configured by your security
company to report to your mobile phone when an
alarm occurs and play back a pre-recorded message
detailing instructions.
The pre-recorded message (up to a maximum of
16 sec. in length) can be changed as many times as
necessary. You need to discuss the recording of your
message with your security company. To change or
program new telephone numbers, see Section 25.2
Programming Domestic Telephone Numbers.
26.1 Acknowledging Domestic Voice
Message Reporting
When an alarm registers at the control panel, the
control panel starts dialling the first telephone
number. The recorded voice message starts playback
as soon as the control panel dials the first telephone
number and repeats itself continuously for 90
seconds.
When you answer the incoming call from the control
panel, wait for the recorded message to end. A series
of short tones follow the recorded message followed
by a 20 sec. pause before the control panel hangs up
and dials the next telephone number.
During the 20 sec. pause, press the [*] button on your
touch-tone telephone. Alternatively, you can use an
optional phone controller (tone generator) if you do
not have a touch-tone telephone.
If an optional DTMF Command Module is
installed by your security company, you can
acknowledge the call during the message
playback by pressing the [#] key. You no
longer need to wait for the pre-recorded
message to end.

27.0 Basic Pager Reporting

This feature is only applicable if your system is
reporting to a pocket pager. Basic pager reporting
requires some interpretation of the numbers that
appear on the display. It is possible to differentiate
between 1000 different systems when a number of
control panels are reporting to the one pocket pager.
27.1

Basic Pager Display Information

Subscriber ID Number
This is the identification number of the control panel
and can only be programmed by your installer.
Bosch Security Systems | 6/04 | 920036O.OG.162
Domestic Voice Message
Zone Status
The zone status display shows you the status of each
zone (1 to 8). Table 15 describes what each number
means when displayed on the zone status display.

Table 15: Zone Status Display Descriptions

Number Zone
Displayed Description
0 Zone Normal
Indicates the corresponding zone is in the
sealed state.
1 Alarm
Indicates the corresponding zone is unsealed
and in alarm condition.
2 Zone Bypassed
Indicates a system operator manually isolated
the corresponding zone. See Section 13.0
Isolating Zones for information on how to
manually isolate a zone(s) prior to arming the
system.
3 Zone Trouble
Indicates a zone was left unsealed after the
end of exit time.
System Status
The system status information is divided into four
digits.

Table 16: System Status

System Status Description
Display
First digit Indicates whether the system is armed
or disarmed:
8 = Disarmed
9 = Armed
Second digit Indicates which codepad alarm was
triggered by the operator:
0 = No Codepad Alarm
1 = Codepad Panic or Duress Alarm
2 = Codepad Fire Alarm
3 = Codepad Medical Alarm
Third digit Indicates when the AC mains supply has
failed:
0 = AC Supply is normal
1 = AC Supply has failed
Fourth digit Indicates when a system fault has
occurred at the control panel:
0 = System Normal – There are no
faults.
1 = System Fault – There is a fault
registered by the control panel.
EN | 17