Download Print this page

Bosch CP050B Installer's Reference Manual

Night arm station

Advertisement

Quick Links

CP050B
Night Arm Station
Security Systems
Installer Reference Guide
EN
Security System

Advertisement

loading

Summary of Contents for Bosch CP050B

  • Page 1 CP050B Night Arm Station Security Systems Installer Reference Guide Security System...
  • Page 2: Operation

    CP050B - Night Arm Station The CP050B Night Arm Station allows you to arm and disarm the system in either PART Mode 1 or PART Mode 2 by simply pressing a single button. Arming in PART Mode automatically disables all zones that you do not wish to detect intrusion (e.g.
  • Page 3 Press both buttons together for 2 seconds to trigger a Panic Alarm. Once an alarm has been triggered you will need to enter a valid code from a keypad to cancel the alarm. Figure 1: CP050B Buttons and Indicators Bosch Security Systems 10/12 CP050B FTR1.1...
  • Page 4 System Status Status Power Fault or Keypad Extinguish Mode System Disarmed, All Zones Sealed FLASHING System Disarmed, Zone (s) Not Sealed System Fully Armed System Fully Armed With Alarm Table 1: CP050B Status Indicators Bosch Security Systems 10/12 CP050B FTR1.1...
  • Page 5 The CP050B is seen by the system as if it were a keypad device for the purpose of addressing. This means that the address selected for each Night Arm Station will consume or occupy the corresponding Keypad address. No Keypad or Night Arm Station can be set to the same address.
  • Page 6 Programming Each CP050B is treated by the panel as if it were a standard keypad from the point of view of programming options. This means that to change parameters for a Night Arm Station which is configured for address 3 you would need to select Keypad 3 under the devices menu and change the required parameters..
  • Page 7 Operating Environment: 0˚ to 55˚C RH 5 to 85% at 30˚C non-condensing. The CP050B can be directly installed onto a cavity or plaster wall using appropriate fixings or onto a solid Fixing Method: masonry or brick wall using a standard height GPO mounting block (Clipsal or Similar).
  • Page 8 Bosch Security Systems 25 Huntingwood Drive Huntingwood, NSW 2148 Australia Phone: +612 9672 1777 Facsimile: +612 9672 1717 © 2012 Bosch Security Systems CM050BIRG Issue FTR1.1...