Pnp / Pci Configuration - Intel ESM-2740 User Manual

3.5.6

PnP / PCI Configuration

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed
the CPU itself uses when communicating with its own special components. This section
covers some very technical items and it is strongly recommended that only experienced
users should make any changes to the default settings.
3.5.6.1 Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System
Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and the
system reconfiguration has caused such a serious conflict that the operating system cannot
boot.
The choice: Enabled, Disabled.
3.5.6.2 Resources Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot
and Plug and Play compatible devices. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system such as Windows®95. If you set
this field to "manual" choose specific resources by going into each of the sub menu that
follows this field (a sub menu is preceded by a " ").
The choice: Auto, Manual.
3.5.6.3 IRQ / DMA Resources
When resources are controlled manually, assign each system interrupt a type, depending
on the type of device using the interrupt.
ESM-2740/2743 User's Manual
User's Manual
65