Replacing The Standard Control Panel; Figure 37. Removing The Standard Control Panel From The Chassis - Intel Chassis SR1450 User Manual

Server chassis

Hide thumbs Also See for Chassis SR1450:

Table of Contents

Hardware Installations and Upgrades

Replacing the Standard Control Panel

Your server must be operated with a control panel installed. The steps for replacing the Standard

Control Panel are listed below.

CAUTION

The control panel is NOT hot swappable. Before removing or replacing the

control panel, you must first take the server out of service, turn off all

peripheral devices connected to the system, turn off the system by

pressing the power button, and unplug the AC power cord(s) from the

system or wall outlet.

1. Observe the safety and ESD precautions at the beginning of this book. See

Information."

2. Power down the server and unplug all peripheral devices and the AC power cable(s).

3. Remove the chassis cover. For instructions, see

4. Disconnect the front panel cable and the USB cable from the front panel control board at the

rear of the control panel.

5. Press the latch at the back of the control panel. See letter "A" in the figure below.

6. Slide the control panel out through the front of the chassis. See letter "B" in the figure.

7. Slide the replacement control panel into the chassis until it clicks into place.

8. Connect the front panel cable and the USB cable to the replacement control panel.

9. Install the chassis cover. For instructions, see

10. Plug all peripheral devices and the AC power cable(s) back into the server.

"Removing the Chassis

"Installing the Chassis Cover."

"Safety

Cover."

TP01619

Table of Contents