Roll Media - Brady 2461 Operator's Manual

3.1.1

Roll Media

This loading method is roll type media applications. To load:
ΠSlide the Roll Media
onto the Media Hub
until it rests against the
Backstop.
• Route the media as
shown: under
Media Idler, through
the Media Sensor, then
out the front of the
printer.
Ž Raise and slide the
Media Guide over until
it rests lightly against the edge of the media.
• Position the Media Sensor; see Section 3.2.
• If your application uses thermal transfer media, load ribbon (see Section
3.3); otherwise continue.
' Lower the Printhead Assembly and rotate the Printhead Latch completely
back into the locked position. Close the Access Cover.
' Turn 'On' the printer. After 'Ready is displayed, press and hold the FEED
key until at least one label gap or mark is advanced; see Section 3.4.
+
If using less than full width media, adjust the Leveling Cam; see
Section 5.1.1.
the
15