Kenmore Top-Mount Refrigerator Owner's Manual page 44

Us Hg e e
aute at e
Before you turn the ice maker on, be sure that it is
attached to a water supply. Refer to the "Attaching the
optional ice maker to a water supply" section.
÷ The ON/OFF lever is a wire signal arm O. Push the arm
down (_ to start making ice automatically, and push it
up _) to shut off the ice maker _.
÷ If you remove the ice bin, raise the signal arm to shut off
the ice maker. When you replace the bin, push it in all
the way and lower the ice maker signal arm to the
ON position.
÷ It is normal for the ice to be attached at the corners. They
will break apart easily.
÷ The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as overnight.
÷ If ice is not being made fast enough and more ice is
needed, turn the Refrigerator Control toward a higher
number in half number steps. (For example, if the control
is at 3, move it to between 3 and 4.) Wait 24 hours and,
if necessary, gradually turn the Freezer Control toward
COLDER, waiting 24 hours between each increase.
REd, EMBER:
÷ The quality of your ice will be only as good as the quality
of the water supplied to your ice maker.
÷Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided, make
sure the water softener is operating properly and is
well maintained.
44