Table of Contents
Advertisement
Auto Scanning
Auto Scan automatically switches among all the active Computer Ports that are
accessible to the currently logged on User at regular intervals, so that he can
monitor their activity automatically. (See Scan Mode of the OSD F3 SET
function, p. 24 for information regarding accessible ports).
Setting the Scan Interval
The amount of time Auto Scan dwells on each port is set with the Scan
Duration setting of the OSD F3 SET function (see p. 24). You can change the
scan interval before activating Hotkey Auto Scanning, if you wish, with the
following Hotkey combination:
1. Invoke Hotkey Mode (see p. 37).
2. Key in [Q] or [A] [n]
Where [Q] , [A] are the letters Q and A, and [n] is a number from 1-255
that represents the number of seconds for the dwell time.
The letters Q or A and the numbers display on the Command Line as you
key them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey Mode, and are
ready to invoke Auto Scanning.
Chapter 4. Hotkey Operation
39
Advertisement
Table of Contents
