Download  Print this page

Important Safety Instructions; Electrical Requirements - Kenmore 363.63672 Installation Instructions Manual

Speedcook ovens
Hide thumbs

Advertisement

Table of Contents
Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
This product requires a thre_prong
grounded
oudet.
The installer must pecfonn a gTound continuity check on
the power outlet box before beginning the installation to
instu'e that the outlet box is properly grounded,
ff not
properly grounded,
or if the outlet box does not meet
electrical requirements
noted (under ELECIa_CAL
REQUIREMENTS),
a qualified electrician should be
employed to correct any deficiencies.
I CAUTION:
For personal safety, remove
house fuse or open circuit
breaker before beginning
installation to avoid severe
or fatal shock injury.
CAU1]ON:
Fer p o on
the m ou g
surface must be capable of supporting
the cabinet load, in-
adch'fion to the added weight of this 63-85 pound product,
plus additional oven loads of up to 50 potmds or a total
weight of 113-135 potmds.
CAUTION:
For personal
safety, this product
cannot be installed in cabinet arrangeme_ats
such as an
island or a peninsula.
It must be mounted
to BOTH
a top cabinet AND a walL
NOTE: For easier installation mad personal safety, it is
recommended that two people install this product.
IMPORTANT--_
READ CAREFULLY. FOR
PERSONAL
SAFETY, THIS APPIJANCE
MUST BE
PROPERLY
GROUNDED
TO AVOID SEVERE OR
FATAL SHOCK.
The power cord of this
appliance is equipped with
a _-ee-pro_g _o_mding)
l_ug which mates with
a standard three-prong
(groundhlg) wall x_eptade
to minimize the possibility
of dec_wic shock hazard
from this appliance.
You should have the wall receptacle and circuit checked
by a qualified elec_clan
to make sure the receptacle is
properly grounded.
Where a standard two_reng wall receptade is
encountered, it is very important to have it replaced
with a properly grounded three-prong wall receptacle,
installed by a qualified electrician.
DO NOT, LrNDER ANY CIRCUMSTANCES,
CUT,
DEFORM
OR REMOVE ANY OF THE PRONGS
FROM THE POWER CORD. DO NOT USE WITH
AN EXTENSION CORD.
ELECTRICAL
REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 15 amps and
1.70 kilowatts. This product must be connected
to
a supply circuit of the proper voltage and frequency.
Ware size must conform to the requirements
of the
National Electrical Code or the prevailing local code for
this kilowatt rating. The power supply cord and plug
should be brought to a separate 15 to 20 ampere branch
circuit single grounded outlet. The outlet box should be
located in the cabinet above the oven. The outlet box and
supply circuit should be installed by a qualified electrician
and conform to the National Electrical Code or the
prevailing local code.
3

Advertisement

Table of Contents
loading

  Also See for Kenmore 363.63672

  Related Manuals for Kenmore 363.63672