USE TOP CABINET TEMPLATE
You need to drill holes for the top support
a hole large enough
for the power cord to fit through
and a cutout large enough
for the exhaust adapter.
• Read the instrucdons
on the TOP CABINET
• Tape it underneath
the top cabinet.
• Drill the holes, following the instructions
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet
FOR TOP EXHAUST
_J] Remove and save screws that hold blower plat e to
_ -'<-- Blower P lateScrews
Back of Oven
Slide the blower plate from under its retaining
flange and lift it off. Remove and save screw that
holds the blower motor to oven.
pull out the blower
to allow you to adjust
Roll the blower unit 90 ° so that fan blade openings
are facing up.
Make sure wires remain
of the motor