Kenmore 363.63672 Installation Instructions Manual page 17

Installation Instructions
I_ Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
BeforeRerouting After Beroudng
Wires RoutedThrough Right Side Wires RoutedThroughleft Side
[_ Roll the blower unit 90 ° so that fan blade openings
are facing out tile back of the oven.
BeforeRolling
Oven Oven
[] Place the blower unit back into the opening.
EndA
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rein"of ovep_
_] Replace the blower in the plate posidon
same
as before with the screws.
, €. B'°B, eorwPLT ws
BeokofOven
[_ Insert the tabs on each side of the damper into
file holes at the inside rear of the adapter.
_-_ Exhaust
Adapter
[_ Attach the exhaust adapter to the rear of the
oven by sliding it into the guides at the top center
of the back of tile oven.
ExhaustAdapter .,_
Slide exhaust _
adapterinto
guideson
oven rear. I._
_ Damper
(hinge sideup)
_V "_'_r_ Screws
Tabs
, Guides
Push in securely until it is in the lower locking
tabs. Take care to assure the damper hinge is
installed so that it is at the top and that the
damper swings freely.
[_ Secure the exhaust adapter to the oven with the
two bronze metal screws provided.
17