Outside Top Exhaust; Attach Mounting Plate To Wall - Kenmore 363.63672 Installation Instructions Manual

Installation Instructions
OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adjust Blower
CA. Install Adapter
C5. Mount Oven
C6. Adjust Exhaust Adapter
C7. Connect Ductwork
1
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
[] Remove the toggle wings from the bolts.
[] g
Insert the bolts into the mounting plate throu h
the holes designated to go into drywall and
reattach the toggle wings to Y_"onto each bolt.
To use toggle bolts:
Mounting
Plate.
SpacingforToggles
Mare ThanWall
-_.,--_Thickness
[eWings
BoltEnd
[] Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
[_] Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
19