Top Exhaust - Kenmore 363.63672 Installation Instructions Manual

Installation Instructions
ADAPTING BLOWER FOR
TOP EXHAUST (continued}
[_] Place the blower unit ]_ack into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
[_ Secure blower unit to oven with the removed
screw
in Step 2. Insert the screw in bottom right screw
hole on the back of the oven.
Re lace
[] p
Step 1.
blower plate with the screws removed in
= _*"_ BlowerPlate Screws
• =r-... BlowerMotor
Screw
ASSEMBLE AND INSTALL
ADAPTER
_ -.,,t--_ Damper
t J
__ Adapter
_ BlowerPlate
0vee
[_Place the oven in its upright position_ with the top
of the unit facing up.
[_ Insert the tabs on each side of the damper into the
holes at the inside rear of the adapter.
[3"] Attach the exhaust adapter to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
I-_ MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY,,WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not ttsed,
case damage may occur from over tightening
screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch
cord or lift oven by
pulling cord.
[-_Lift oven, tilt it forwar_
and hook slots at back
bottom edge onto
two lower tabs of
mounting plate.
21