Disconnecting A Telnet Session; Disabling Telnet Access - 3Com 9100 User Manual

7 Save your configuration changes so that they will be in effect after the
8 When you are finished using the facility, log out of the switch by typing
Disconnecting a
Telnet Session
1 Log in to the switch with administrator privileges.
2 Determine the session number of the session you want to terminate by
3 Terminate the session by using the following command:
Disabling Telnet
Access
For example:
config iproute add default 123.45.67.1
next switch reboot, by typing
save
For more information on saving configuration changes, refer to
Chapter 10.
or
logout quit
An administrator-level account can disconnect a management session
that has been established by way of a Telnet connection. If this happens,
the user logged in by way of the Telnet connection is notified that the
session has been terminated.
To terminate a Telnet session, follow these steps:
using the following command:
show session
clear session <session_number>
By default, Telnet services are enabled on the switch. You can choose to
disable Telnet by entering:
disable telnet
To re-enable Telnet on the switch, at the console port enter
enable telnet {access-profile <access_profile> | none} {port
<port_number>}
You must be logged in as an administrator to enable or disable Telnet.
Using Telnet 49