104
C
7: Q
S
(Q
S)
HAPTER
UALITY OF
ERVICE
O
The command to clear the FDB is as follows:
clear fdb
Blackhole
Using the
option configures the switch to not forward any
blackhole
packets to the destination MAC address on any ports for the VLAN
specified.
The
option is configured using the following command:
blackhole
create fdbentry 00:11:22:33:44:55 vlan default blackhole
Broadcast/Unknown Rate Limiting
It is possible to assign broadcast and unknown destination packets to a
QoS profile that has the desired priority and bandwidth parameters.
Broadcast/unknown rate limiting is an extension of the QoS feature used
for destination MAC addresses.
For example, if you want to limit broadcast and unknown traffic on the
VLAN default to the bandwidth and priority defined in QoS profile qp3 ,
the command is:
create fdbentry ff:ff:ff:ff:ff:ff vlan default dynamic qp3
Verifying MAC-Based QoS Settings
To verify any of the MAC-based QoS settings, use either the command
show fdb perm
or the command
show qosprofile <qosname>
This category of traffic groupings consists of prioritization bits used in
Packet Groupings
IEEE 802.1p packets.