Alcatel-Lucent 8950 AAA User Manual page 242

Message Logging
............................................................................................................................................................................................................................................................
Every panel has a fixed section that contains four fields, as described in
Table 16-3 Log Channel Configuration Panel–Properties tab
Field
Name
Type
On-Error
Default-Channel
Every panel contains three tabs that may be used to configure specific aspects of the log
channel. They are the Properties, Advanced, and Documentation tabs. The use and
contents of the tabs are dependent on the destination/output type of log channel selected.
............................................................................................................................................................................................................................................................
1 6 -1 0
Description
The unique name for this channel.
Pre-set with the selected destination type.
Name of an alternate channel to use if an error is
encountered while writing to this channel.
8950 AAA cannot determine if a Syslog server is
responding. If syslog is your default output channel,
you might wish define a redundant channel using a
local file as the destination. See
Outputs" on page 22.
If selected, then this channel is the Default-Channel.
Only one channel may be designated at the Default-
Channel. If you designate a channel as the Default-
Channel it will automatically override any previous
Default-Channel selection.
If not selected, then the server uses the last selected
default.
The server uses this value when configuring Log
Rules. It can be changed, but remember to check
your Log Rules after changing. For more
information, please see
Log Channels
Table 16-3.
"Multiple Log
"Log Rules" on page 32.
365-360-001R6.0
Issue 1, December 2008