Alcatel-Lucent 8950 AAA User Manual page 183

Configuring 8950 AAA USSv2
............................................................................................................................................................................................................................................................
Figure 10-5 The USSv2 StateServer Configuration–Replication tab properties
Table 10-2
screen.
Table 10-2 USSv2 StateServer Configuration–Replication tab properties
Field Name
Replicated Servers
Replication Map
Obliterate
Action buttons of the USSv2 Replicated Servers Section
The USSv2 Configuration panel
sets of Action buttons that appear in the 8950 AAA USSv2 Configuration panel, as shown
in Figure
The action buttons that are in the bottom section are used to configure Replicated Servers.
The Top set of action buttons are as shown in
............................................................................................................................................................................................................................................................
365-360-001R6.0
Issue 1, December 2008
explains each of these fields and the field descriptions that are displayed in this
10-2.
Description
A list of zero or more names of defined nodes to which this
model will replicate. Note that if any names are given,
exactly one of them has to match the name of the local
Diameter Origin-Host property of each node.
Specifies the mapping to be applied when merging
remotely replicated entries into local, pre-existing entries.
The fall back time-out to use to terminally remove entries
marked for deletion out of the database in case a delete
event is not acknowledged.
(Figure 10-2) contains two sections that consists of 2
Figure 10-3
USSv2 Configuration
and are as explained earlier.
1 0 - 5