............................................................................................................................................................................................................................................................

Adding Attribute Sets to Your Policy

About adding Attribute sets

This section covers the use of the Policy Wizard to create attribute sets and assumes that

you are creating or editing a policy and have already completed the following

configuration steps: defining a user profile source, defining an authentication source,

defining storage for accounting data, and setting session limits. You should now see the

Attribute Set for Policy panel as shown in

Figure 9-10 Attribute Set Panel in the Policy Wizard

If you do not want to use an attribute set with this policy, make sure the option Use

Attribute Sets is not selected and click Next to advance to the final Policy Wizard panel.

Please refer to the section

Wizard.

Use Attribute Sets

To use attribute sets with this policy, select Use Attribute Sets. This is the default setting.

You set which attribute set is used for this policy in the Attribute to use for this Policy

frame.

365-360-001R6.0

Issue 1, December 2008

Figure

"Reviewing Your Policy" on page 25

Adding Attribute Sets to Your Policy

9-10.

to complete the Policy

9 - 1 9

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Adding Attribute Sets To Your Policy - Alcatel-Lucent 8950 AAA User Manual