Num Lock After Boot; Memory Test; Quiet Boot - Acer M9N System User Manual

To prevent data loss, set this parameter set to
using a hard disk with more than 504 MB capacity that was previously
configured through LBA mode. If you use a hard disk configured
through cylinder-head-sector (CHS) mode, set this parameter to
. The default is
Disabled
Hard Disk 32-bit Access
Enabling this parameter improves system performance by allowing
the use of the 32-bit hard disk access. This enhanced IDE feature
only works under DOS, Windows 3.x, Windows 95, and Novell
NetWare. If your software or hard disk does not support this function,
set this parameter to Disabled
3.2.7

Num Lock After Boot

This parameter allows you to activate the Num Lock function upon
booting. The default setting is
3.2.8

Memory Test

When set to Enabled , this parameter allows the system to perform a
RAM test during the POST routine.
system detects only the memory size and bypasses the test routine.
The default setting is Disabled
3.2.9

Quiet Boot

This parameter enables or disables the quiet boot function. When set
to , BIOS is in graphical mode and displays only an
Enabled
identification logo during POST and while booting. After which the
screen displays the operating system prompt (such as DOS) or logo
(such as Windows 95).
system automatically switches to text mode.
BIOS Utility
Enabled
.
Enabled
. The default is Enabled
.
Enabled
When set to
.
If any error occurred while booting, the
if you are
.
Disabled , the
3-9