Troubleshooting - Acer M9N System User Manual

4.1.4

Troubleshooting

If you can't connect to a server, try the suggestions here, then turn to
page 14.
Make sure you're using the drivers for this adapter. The driver
filename contains the letter B (for example, E100BODI.COM).
If you're replacing an existing adapter, make sure the LINK
statement in your NET.CFG is correct for the new adapter. For
example, the LINK statement for a NetWare client should be:
LINK DRIVER E100BODI
Verify FRAME type in your NET.CFG file matches your server.
If setting up a server, check your LOAD and BIND statements.
Make sure the PCI slots are busmaster-enabled (see page 17).
Make sure adapter and hub duplex mode match. See page 11
for more information on duplex modes for the PRO/100 TX
adapter.
Make sure the network cable is securely attached to both the
adapter and hub port and the adapter LNK light is on.
At 100 Mbps, make sure you are connected to a 100BASE-TX
hub (not a 100BASE-T4).
Test the adapter.
Check the README files.
4-4 User's Guide