Test The Adapter With A Responder On The Network (Optional) - Acer M9N System User Manual

2. Insert the Intel Configuration and Drivers disk in a floppy drive,
switch to that drive, and at the DOS prompt, type
SETUP
3. If you have more than one Intel PRO series PCI adapter in your
computer, an adapter selection menu appears on the screen.
Select the adapter you want by noting the Ethernet address. See
page 10 for more information on multiple adapters.
4. Select Automatic Setup from the Main menu. Then follow the
instructions on the screen. (If you want to test the adapter with a
responder on the network, see the next procedure.)
Setup displays the adapter's configuration, then runs a series of
diagnostic tests that makes sure the adapter and network are
functioning properly. If Setup finds a problem, it displays the
results and some possible solutions.
5. When Setup finishes the tests, the Install Network Drivers screen
appears.
6. Select the driver you want to install. Setup can install a NetWare
client driver for you. If you're installing other drivers, Setup
displays a README file with installation instructions.
4.1.3 Test the adapter with a responder on the
network (optional)
Setup can test the adapter more thoroughly if you have a responder
on the network while running the tests.
1. Go to a computer on the network with any EtherExpress adapter
installed (except EtherExpress 32 or EtherExpress 16 MCA).
2. Run the appropriate configuration program for the installed
adapter and set it up as a responder.
3. Return to the computer with the new adapter. Run Setup and
make the new adapter a sender. Test the adapter.
LAN Information 4-3