Troubleshooting - Acer M9N System User Manual

5. Click Test.
If you've just added the adapter, the network driver is not active
and the diagnostics will test the adapter and its connection to the
network.
If you're testing an existing PRO/100 TX adapter, the network
driver will probably be active and the diagnostics will test the
driver. This diag-nostic tracks the driver's actual network activity.
6. Click OK to accept the adapter's configuration.
7. Click OK in the Network Settings dialog box and when prompted,
restart Windows NT.
8. To install multiple adapters, repeat this procedure for each new
adapter. In addition, read the notes on page 10.
To run the PROSet software at any time, double-click the Intel
PROSet icon in the Control Panel.
4.2.3

Troubleshooting

If you can't connect to a server, or if Windows NT reports an error
while trying to connect, try the suggestions here, then turn to page 14.
Make sure you're using the drivers that are on the drivers
diskette that ships with this adapter.
Make sure the driver is loaded and the protocols are bound. See
the Network Bindings dialog box in Windows NT.
Make sure the PCI slots are busmaster-enabled.
Make sure the network cable is securely attached to both the
adapter and hub port and the adapter LNK light is on.
Make sure the hub port is configured for the same duplex mode
as the adapter. See page 11 for more information on full duplex.
4-6 User's Guide