Fujitsu SPARC ENTERPRISE M9000 Service Manual page 79

Status Display of LEDs Defined Individually for Each FRU (Continued)
TABLE 2-12
LED
FRU Type
XSCFU and IOU ACT
(display part for
LAN)
LINK SPEED
HDD READY
CHECK
PCI card (Power)
(inside an external
I/O expansion unit)
(Attention)
Display
Lit (green)
Off
Lit (amber)
Lit (green)
Off
Lit (green)
OK
Blinking
(green)
Off
Lit (amber)
Blinking
(amber)
Off
Lit (green)
Off
Lit (amber)
Blinking
(amber)
Off
Meaning
Indicates that communication is being performed
through the Ethernet port (LAN port).
Indicates that no communication is being performed
through the Ethernet port (LAN port).
Only for an IOU: Indicates that the communication
speed is 1G bps.
Indicates that the communication speed is 100M bps.
Indicates that the communication speed is 10M bps.
Indicates that the HDD is in operation. In this state, the
HDD cannot be removed (cannot be replaced).
Indicates that the HDD is being connected. In this state,
the HDD cannot be removed (cannot be replaced).
Indicates that the HDD can be replaced.
Indicates that an error was detected in the HDD.
However, this LED remains on for a few minutes
immediately after power-on (until the start of
initialization). It does not indicate an error during that
time.
Indicates that the HDD is a replacement target.
Indicates that the HDD is in the normal state.
Indicates that power is being supplied to the PCI slot.
Indicates that the PCI card in the PCI slot is stopped.
Indicates that an error occurred in the hardware of the
PCI slot.
Indicates that the PCI card in this PCI slot is a device to
be replaced.
Indicates that the hardware of the PCI slot is normal.
Chapter 2 Product Overview and Troubleshooting 2-33