Fujitsu SPARC ENTERPRISE M9000 Service Manual page 544

PSU
active replacement, 9-8
cold replacement, 9-12
hot replacement, 9-8
PSU backplane, B-38
PSU BP
cold replacement, 20-1
R
rack-mountable dual power feed, B-34
rack-mountable dual power feed option, 24-1
rating label, 2-11
replacement of CPU/memory board unit (CMU),
CPU, and DIMM, 6-1
replacing a CPU module, 6-30
S
sensor unit, B-23
sensor unit replacement, 21-1
server and system configuration, 2-23
servers BPs
cold replacement, 20-1
showlogs command, 2-34
SNSU
cold replacement, 21-4
software and XSCF firmware configurations, 2-24
Solaris troubleshooting commands, traditional, 2-37
standard label, 2-11
state display, 2-18
status display, 2-32
SWBP
cold replacement, 23-5
switch backplane, B-43
switch backplane replacement, 23-1
switches, 2-20
switching off the main line switch, 4-34
system configuration, A-1
system name plate label, 2-11
system views, 2-1
T
tape drive unit, B-20
tape drive unit replacement, 15-1
Tape drive unit, cleaning, 3-1
Index-4 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
TAPEU
active replacement, 15-5
cold replacement, 15-9, 15-11
traditional Solaris troubleshooting commands, 2-37
troubleshooting, 2-1
troubleshooting commands, 2-34
types of Replacement Procedures, 4-2
U
UPS controller (UPC)
Cable Connector, D-5
Configuration of Signal Lines, D-2
Connection, D-6
overview, D-1
Power supply conditions, D-4
Signal Cable, D-1
UPC Port, D-1
X
XBU
cold replacement, 17-4
XSCF unit, B-17
XSCF unit replacement, 11-1
XSCFU
active replacement, 11-5
cold replacement, 11-12
required update, E-1