Fujitsu SPARC ENTERPRISE M9000 Service Manual page 308

b. If the lever stops halfway even when the PCI cassette is inserted again, pull
Caution – Do not forcibly push the lever of the PCI cassette when the lever is
pushed but stops halfway. In this case, restore the lever to its original position, and
then reinsert it. If the lever stops halfway even when the PCI cassette is inserted
again, it is possible that the PCI card is not set in the normal position (see a, b, and c
of Step
card, and then reinsert the PCI cassette.
13. From the OS, execute the cfgadm -c connect <PCI_ApId> command to
supply power to the PCI card.
# cfgadm -c connect iou#0_pci#3
14. From the OS, execute the cfgadm -c configure <PCI_ApId> command to
configure the PCI card into the domain.
# cfgadm -c configure iou#0_pci#3
15. From the OS, execute the cfgadm -a command to confirm that the status of the
PCI card has changed from "unconfigured" to "configured."
# cfgadm -a
Ap_Id
iou#0_pci#3
16. Confirm that the replacement components are normal by using the
showhardconf or showstatus command of XSCF.
Unless "*" is displayed for the replacement XSCFU, it is operating normally.
For details of the showhardconf command and showstatus command, see the
SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF User's Guide,
the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF Reference
Manual, or the man page.
Note – The showstatus command displays information on degraded components.
17. Close the door on the server and lock it.
13-16 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
the PCI cassette out from the IOU, and then check whether the PCI card is
set in the normal position (see a, b, and c of
cassette.
11). Pull the PCI cassette out from the IOU, verify the position of the PCI
Type
pci_pci/hp
Receptacle Occupant
:
connected configured
Step 11). Then, reinsert the PCI
Condition
ok