Required Tools; Starting The Task - Fujitsu PRIMERGY RX900 S1 Maintenance Manual

14.6.1 Required tools

Starting and completing the task:
– key for the rack doors (if applicable)
– Phillips Ph2 screw driver
Replacing the baseboard:
– Phillips Ph0 screw driver
– Phillips Ph1 screw driver
– Phillips Ph2 screw driver

14.6.2 Starting the task

Ê Perform the following procedures:
1. "Opening the rack door" on page 40
2. "Locate the faulty server" on page 37
3. "Shutting down the server" on page 41
4. "Sliding the server out of the rack" on page 42
5. "Opening the server" on page 44
6. Remove all PSUs, see
7. Remove all CPUMEMRs, see
I
Before removing the CPUMEMRs, take a note on the installation
slot number for each CPUMEMR. Make sure that you reinstall the
CPUMEMR in the slot it was located before the replacement.
8. Remove all expansion cards and dummy modules in PCIe slots #8 to
#17, see "Expansion cards and BBU" on page 105
I
Before removing the expansion cards, take a note on the
installation slot number for each card. Make sure that you reinstall
the card in the slot it was located before the replacement.
RX900 S1
"Removing the power supply unit" on page 58
"Removing the CPUMEMR" on page 190
Maintenance Manual
Baseboard
277