Table of Contents
Advertisement
8.6.9
Activating the expansion card
Ê Activate the expansion card using either the related PCI hot-plug software or
by pressing the light-pipe switch, see A in
The light-pipe switch flashes green. The slot is in the enable sequence.
Ê Wait until the light-pipe switch is constantly green.
The slot is now powered on.
I
If the light-pipe switch continues to flash, an error has occurred.
Remove the expansion card and repeat the procedure as described
above.
8.6.10 Completing the task
Ê Perform the following procedures to complete the task:
1.
"Installing the rear cover" on page 48
2.
"Mounting the server in the rack" on page 49
3.
"Closing the rack door" on page 51
RX900 S1
Figure
Maintenance Manual
Expansion cards and BBU
69.
147
Advertisement
Table of Contents
