Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 258
Xscf control package (xcp) 109x
Hide thumbs
Also See for SPARC Enterprise M3000:
- Xscf reference manual (560 pages) ,
- Service manual (202 pages) ,
- Product notes (144 pages)
Table of Contents
Advertisement
setroute(8)
236
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2009
Displays usage statement. When used with other options or
-h
operands, an error occurs.
-m address
Specifies the netmask to which routing information is forwarded.
The specified value is a set of four integer values delimited by
the "." (period). The following address form is accepted:
xxx.xxx.xxx.xxx
xxx
If the -m option omitted, one of the following netmask values is
set depending on the address specified in the -n option. If you
specified 0.0.0.0 in the -n option, do not specify the -m option.
■
■
■
An integer from 0–255. Zero suppression can
be used to specify the integer.
In case of a "class A" address:
If the host portion of the address (lower 24 bits) is "0" (e.g.
20.0.0.0), then the netmask value 255.0.0.0 will be set.
If the host portion of the address (lower 24 bits) is other than
"0" (e.g. 20.18.108.10), then the netmask value
255.255.255.255 will be set.
In case of a "class B" address:
If the host portion of the address (lower 16 bits) is "0" (e.g.
136.18.0.0), then the netmask value 255.255.0.0 will be set.
If the host portion of the address (lower 16 bits) is other than
"0" (e.g. 136.18.108.10), then the netmask value 255.255.255.255
will be set.
In case of a "class C" address:
If the host portion of the address (lower 8 bits) is "0" (e.g.
200.18.108.0), then the netmask value 255.255.255.0 will be set.
If the host portion of the address (lower 8 bits) is other than
"0" (e.g. 200.18.108.10), then the netmask value 255.255.255.255
will be set.
Advertisement
Table of Contents
