Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 206

setdscp(8)
Privileges
OPTIONS
EXAMPLES
184 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
Note – The -y and -n options can be used (with or without the -q option) when
running setdscp in interactive mode.
You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
The following options are supported:
-d domain_id Domain identifier. Must be used with -i address option. domain_id
can be 0–23 depending on the system configuration.
Forces setdscp to ignore out of range and address conflict errors
-f
and commits the new settings.
Displays usage statement.
-h
When used with other options or operands, an error occurs.
-i address Specifies an IP address in the IPv4 dotted decimal format.
When used with -m netmask it specifies a network address for
all DSCP links in the system.
When used with -d domain_id it specifies an individual,
domain-specific IP address for use by DSCP.
When used with -s, it specifies the IP address used for the
Service Processor end of all DSCP links in the system.
-m netmask Specifies a netmask address for all DSCP links in the system. Must
be used with -i address.
Automatically answers "n" (no) to all prompts.
-n
Suppresses all messages to stdout, including prompts.
-q
Must be used with the -i address option. Specifies the Service
-s
Processor end of all DSCP links in the system.
Displays a detailed message. If this option is specified with the -q
-v
option, the -v option is ignored.
Automatically answers "y" (yes) to all prompts.
-y
Caution – The IP addresses shown in the following examples are examples only.
When choosing DSCP IP addresses avoid choosing addresses that are used
elsewhere in your local area network (LAN). For information about DSCP IP
addresses refer to the System Configuration chapter of the Administration Guide.