Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 273

Stops the SNMP agent and changes the SNMP configuration to
default
the factory default settings. After using this option, SNMP must
be configured again before the SNMP agent is restarted.
When used with default, the command also stops the SNMP
agent for Sun MC in servers running Sun MC. The Sun MC
configuration is not affected, but to enable SNMP for Sun MC
again, execute the setsunmc(8) command with its -s option –
setsunmc -s
hostname previously set – then, execute
then execute
setsunmc(8).
When used alone or with the value ALL for the optional
disable
mib_name, stops the SNMP agent.
When used with a value other than ALL for the optional
mib_name, removes support for the targeted MIB module. If
support remains for another MIB module, the SNMP agent
remains enabled. If support for both MIB modules is removed,
the SNMP agent is disabled and, therefore, stops. You can specify
only one value at a time for mib_name.
mib_name
Valid MIB modules are:
SP_MIB = XSCF extension MIB
FM_MIB = Fault Management MIB
ALL = All the MIB modules in this list.
Disables the SNMP agent from communicating using SNMPv1/
disablev1v2c
v2c. These versions provide insecure SNMP communication.
sunmc-server, where sunmc-server is the server
setsunmc enable
Name of the MIB module to be disabled.
setsnmp enable
. For more information, see
System Administration
setsnmp(8)
. And
251