To insert the battery:
1.
Align the tabs on the rear edge of the battery with the notches on the rear edge of the battery bay.
2.
Pivot the front edge of the battery down into the battery bay until it is seated. (The battery release
latch will automatically lock into place.)
Hard drive
NOTE:
The hard drive spare part kit does not include the hard drive bracket, hard drive
connector cable, or screws.
Description
1-TB, 5400-rpm, 9.5-mm
750-GB, 7200-rpm, 9.5-mm
750-GB, 5400-rpm, 9.5-mm
640-GB, 5400-rpm, 9.5-mm
500-GB, 7200-rpm, 9.5-mm
500-GB, 5400-rpm, 9.5-mm
320-GB, 7200-rpm, 9.5-mm
320-GB, 5400-rpm, 9.5-mm
Hard Drive Hardware Kit (includes hard drive bracket, hard drive connector cable, and screws)
Before removing the hard drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Remove the hard drive:
1.
Loosen the captive screw (1) that secures the service cover to the computer.
2.
Slide the battery release latch (2) to release the service cover. (The service cover releases (3)
forward.)
48
Chapter 4 Removal and replacement procedures
Battery on page
47).
Spare part number
676521-001
633252-001
634250-001
669300-001
634925-001
669299-001
641672-001
622643-001
686907-001