Table of Contents
Advertisement
Hard drive
Description
Hard drive
●
1 TB 5400 RPM SATA RAW HYBRID 8 GB
●
2 TB 5400 RPM SATA RAW 9.5 mm
●
1 TB 7200 RPM SATA RAW 9.5 mm
Hard drive connector and cable
Before removing the hard drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Optical drive (see
c.
Base enclosure (see
Remove the hard drive:
NOTE:
Use minimal force when lifting the locking bar up on the ZIF connector and disconnecting the cable.
1.
Open the zero insertion force (ZIF) connector to release the hard drive cable (1) from the system board.
Battery on page
34)
Optical drive on page
Base enclosure on page
35)
37)
Component replacement procedures
Spare part number
731999-005
801808-005
766644-005
857462-001
39
Advertisement
Table of Contents
