Table of Contents
Advertisement
Hard drive
Three different SKUs related to storage are offered:
●
Hard drive only
●
M.2 solid-state drive only
Hard drive and M.2 solid-state drive
●
For hard drive only models, install the hard drive into hard drive bay. For solid-state drive only models, install
the solid-state drive into the solid-state drive adapter bracket, and then into the hard drive bay. For hard drive
and solid-state drive models, install the hard drive into the hard drive bay and install the solid-state drive into
the separate solid-state drive connector on the system board. System boards are offered with an additional
M.2 solid-state drive connector for hard drive and solid-state drive models.
NOTE:
The hard drive spare part kit does not include the hard drive bracket.
Description
Hard drives:
1-TB, 5400-rpm
500-GB, 7200-rpm
500-GB, 5400-rpm
Hard drive bracket
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
To remove the hard drive:
1.
Remove the Phillips PM2.5×3.5 screw (1) that secures the hard drive assembly to the computer.
40
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
28).
Optical drive on page
Bottom cover on page
29), if installed.
35).
Spare part number
778192-005
703267-005
778186-005
925354-001
Advertisement
Table of Contents
