Dell M5200 Medium Workgroup Mono Laser Printer User Manual page 139

4<x> The printer detects an unsupported
version of firmware on the installed
Unsupported
firmware card during the power-on
Firmware Card
cycle.
54 Network <x> The printer cannot establish
communications with an installed
Software Error
network port.
54 Std Network
Software Error
55 Unsupported The printer detects an unsupported
flash memory card in one of the
Flash
connectors.
in Slot X
The printer detects an unsupported
55 Unsupported
option card in one of the
Option in Slot X
connectors.
Data has been sent to the printer
56 USB Port <x>
through a USB port, but the USB
Disabled
port is disabled.
56 Standard USB
Port Disabled
Too many drawers with matching
58 Too Many
trays are installed on the printer.
Trays Attached
You have installed an incompatible
59 Incompatible
device.
<device>
<device> is one of the following:
The printer requires replacement of
80 Scheduled
routine maintenance items to
Maintenance
maintain top performance and
avoid print quality and paper feed
problems.
88 Toner Low The printer has detected that the
toner supply in the toner cartridge
is low. If you do not have a toner
cartridge on hand, order one now.
Env Feeder
Tray x
Duplex
Turn the printer off, and then press and
hold Go while turning it on. The printer
reads the code on the system card and
bypasses the code on the firmware
card.
Remove the firmware card.
Press Go to clear the message and
continue printing. The job may not print
correctly.
Program new firmware for the network
interface by way of the parallel port.
Press Menu to open the Job Menu and
reset the printer.
Turn the printer off. Remove the unsupported
option card.
Turn the printer off. Remove the unsupported
option card.
Press Go to clear the message. The
printer discards any data received
through the USB port.
Make sure the USB Buffer menu item in
the USB Menu is not set to Disabled.
See also: USB Buffer
Turn off and unplug the printer. Remove the
additional drawers. Plug in the printer and
turn it on.
Remove the device and press Go to clear the
message.
Replace the maintenance items and reset the
printer maintenance counter, if necessary.
See also: Resetting the maintenance counter
Shake the toner cartridge to utilize the
remaining toner.
Replace the toner cartridge.
Press Go to clear the message and
continue printing. The Supplies
message is displayed until you replace