Dell M5200 Supplementary Manual

Maintenance Kit Installation Instructions
Turn off printer, unplug, and allow it to sit for 30 minutes before performing any of these maintenance procedures.
Duty Cycle: 300,000 Pages @ 5% Coverage
Fuser Removal & Installation:
1. Remove any output options.
2. If a duplex unit is installed, remove the printer from it by using the handholds.
This may require two people.
3. Remove the fuser cover. (If you have a label printer, lift up and remove the
fuser cleaner.)
4. Open the rear access door slightly and pull up at a slight angle to remove.
5. Loosen the two screws on the redrive unit; remove the redrive unit by
pulling outward by the tabs.
6. Loosen the two screws on the fuser asm and pull the fuser from the
printer; to do so, pull the fuser by the metal tab.
7. Install the new fuser in reverse fashion.
Do not touch the new transfer roller or charge roller with your bare hands; oils from skin on
Transfer Roller Replacement:
1. Turn the printer around so the front is facing you; open the front doors
and remove the print cartridge.
2. Unsnap the Transfer Roller Assembly from the left pivot arm.
3. Lift the Transfer Roller Assembly toward the left and remove it from the printer.
4. Leave the protective wrapper on the transfer roller and insert into the
bearing on the right. Then snap the left end of the roller into position.
5. Remove the protective wrapper from the roller and discard.
Charge Roller Replacement:
1. Locate the charge roller toward the rear of the opening, grasp it with your left hand and push the right mounting bracket
away until the charge roller drops out.
The following parts are included in your Maintenance Kit
Description
Fuser
Transfer Roller
Charge Roller
Pick Rolls
* * * AT T E N T I O N * * *
the transfer roller can cause print quality defects.
Dell M5200
Dell RO238
Part Number
M1896
N1497
J1756
M1546
****CAUTION****