Reinstallation To Multiple Logical Drives - NEC Express5800/120Rh-2 User Manual

7.
Select the proper SCSI Adapter and press Enter.
– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003 (When
HostRAID is installed.)
– MegaRAID SCSI 320-1 Controller Driver (When N8103-80F board is installed.)
– MegaRAID SCSI 320-2 Controller Driver (When N8103-81F board is installed.)
– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003 (When N8103-86
board is installed.)
Continue performing tasks according to the subsequent messages that appear.
After installation is completed, be sure to execute the tasks described in "Driver Installation and
Advanced Settings" and "Updating the System" of this manual.

Reinstallation to Multiple Logical Drives

This subsection describes the procedure for reinstalling the operation system if the multiple logical
drives exist.
Before Re-installing the Operation System
Be sure to make backup copies before re-installing the operation system just in case.
Re-installing the Operation System
1.
Start the clean installation following the procedure described in this manual.
2.
Specify the partition in which you want to install the operating system when the following
message appears:
The following list shows the existing partitions and
unpartitioned space on this computer.
Use the UP and DOWN ARROW keys to select an item in the list.
* Cannot modify the drive letter of your system or boot volume. Confirm the proper
drive letter is assigned and then, continue the setup.
3.
Continue the clean installation again following the procedure described earlier in this
chapter.
The drive letter of the re-installed system may differ from the one of the previous system.
If you need to modify the drive letter, modify it according to the "Procedure for
Modifying the Drive Letter".
Appendix E E-7