System Settings - Xerox DocuPrint 305 User Manual

Ethernet
Specifies the communication speed/connector type of the Ethernet interface.
[Auto] (default)
Select this to switch between 100BASE-TX and 10BASE-T automatically.
[100BASE-TX]
Select this to use 100BASE-TX only.
[10BASE-T]
Select this to use 10BASE-T only.
IPX/SPX Frame Type
Specifies the operational frame type of IPX/SPX.
[Auto] (default)
Select this to automatically configure the frame type.
[Ethernet II]
Select this to use the Ethernet frame type.
[Ethernet 802.3]
Select this to use the IEEE802.3 frame type.
[Ethernet 802.2]
Select this to use the IEEE802.3/IEEE802.2 frame type.
[Ethernet SNAP]
Select this to use the IEEE802.3/IEEE802.2/SNAP frame type.
Filter
IP Filter
Specifies whether to limit IP addresses that receive print jobs. Select [On] if you do not want
to receive print jobs from non-registered IP addresses. The default is [Off].
Note
• Even if [On] is selected, it becomes invalid when all the registered IP addresses are "000.000.000.000".
IP Address
Registers the IP addresses that are allowed to receive jobs if you want to limit the IP
addresses. You can specify up to 10 IP addresses. Specify the address masks for the
registered IP addresses. Enter the IP addresses and address masks in the format of
xxx.xxx.xxx.xxx. You can set values between 0 and 255 for xxx. For example, if you specify
"126.249.110.23" in [IP address] and "255.255.255.0" in [IP Address Mask], the addresses
that are allowed to receive jobs are "129.249.110.* (1 to 254)".

System Settings

[System Settings] menu is used to make the printer operation settings such as for alarm and
power saver mode.
Alert Tone
Specifies whether to turn on the alarm when an error occurs in the printer. The default is
[Off]. You cannot adjust the sound volume.
86
4 Settings on the Control Panel
*3 (refer to P. 95)