Xerox DocuPrint 305 User Manual page 118

Error code
016-755
016-761
016-762
016-796
016-797
016-799
116-701
116-702
116-703
116-710
116-714
116-720
116-740
116-746
116-747
118
5 Troubleshooting
Cannot print PDF file that does not have print permission.
Use Adobe Acrobat to cancel print prohibit settings in the PDF file, and print again.
Refer to
• Adobe Acrobat related manuals
Error in image processing.
When [High Resolution] is selected for [Print Mode] in the [Graphics] tab, change it to [Standard]
and print again. If this fails, select [On] for [Page Print Mode] on the [Detailed Settings], and print
again.
Refer to
• [Print Mode] / [Page Print Mode]: Online Help for the printer driver
Uninstalled printer language selected.
This printer can process HP-GL, HP-GL/2, TIFF and PDF data. Install the PostScript software kit
(optional) to send PostScript data.
E-mails without attachments are deleted when selections to print only the attachments of received
e-mails are specified.
To print both the e-mail and the mail header, change the settings in [Properties] of CentreWare
Internet Services.
Refer to
• Online Help for CentreWare Internet Services
E-mail sent to this printer using E-mail Print feature has a wrong address.
Specify the correct address and send again.
Refer to
• "2.10 Printing via E-mail - E-mail Printing" (P. 50)
Wrong combination of print parameters, like selecting to print on custom size paper and setting
[Auto] for [Paper Source] on the printer driver and [Auto] for [Paper Size] in trays 1 to 4 on the
control panel.
Check the print parameters.
Cannot perform 2 sided printing due to insufficient memory.
You are recommended to increase the memory.
The job was printed using substitute fonts.
Check the print data.
Error in PostScript (optional).
Check the print data or uncheck the bi-directional communication check box of the printer driver.
Received data has exceeded the spool size of HP-GL and HP-GL/2. The printer may not be able
to determine the original size accurately.
Increase the auto layout memory allocation for HP-GL and HP-GL/2 or install the hard disk
(optional).
Command error in HP-GL and HP-GL/2.
Check the print data.
Cannot print due to insufficient PCL memory.
Disable unnecessary ports or adjust the buffer size for each memory.
You are also recommended to increase the memory.
Numeric data error has occurred as a number exceeding the printer limit value has been used in
the print data.
Check the print data.
The specified form is not registered.
Use a registered form or register the current form.
The paper margin value is too large for the HP-GL and HP-GL/2 valid coordinates area.
Reduce the paper margin value and print again.
Reason/Action