Initialize Nvm; System Settings - Fuji Xerox DocuPrint P255 dw User Manual

• Initialize NVM

Purpose:
To initialize wired network data stored in Non-Volatile Memory (NVM). Enabling this feature and
rebooting the printer will reset all the wired network settings to their factory default values.
Values:
Yes
No*
* Factory default menu setting
• PS Data Format
Purpose:
To set the PS data communications protocol. To make any changes effective, turn off the printer and
then turn it back on.
Values:
Auto*
Standard
BCP
TBCP
* Factory default menu setting

System Settings

Use the System Settings menu to configure a variety of printer features.
• Power Saving Timer
Purpose:
To specify a time period before the printer enter each power saver mode.
Values:
Low Power
Timer
Sleep Timer
* Factory default menu setting
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room
lights and you notice them flickering. Otherwise, select a high value to keep your printer available for
frequent use with the minimum warm-up time.
The printer automatically exits a power saver mode when it receives a print job from a computer.
Alternatively, you can manually bring it back to the ready-to-print state by pressing the
Saver) button. Whether the printer is in Low Power or Sleep mode, it will take about 25 seconds for
the printer to resume the ready-to-print state.
168 Using the Operator Panel Menus
Initializes the wired network data stored in NVM.
Does not initialize the wired network data stored in NVM.
Sets the PS data communications protocol automatically.
Sets the PS data communications protocol to Standard.
Sets the PS data communications protocol to BCP.
Sets the PS data communications protocol to TBCP.
By default, the printer enters Low Power mode in one minute
1min*
of inactivity after completion of the last job. You can change
1min - 30min
the Low Power Timer setting within a range from 1 to 30
minutes.
By default, the printer enters Sleep mode in six minutes of
6min*
inactivity starting from the moment it entered Low Power
6min - 11min
mode. You can change the Sleep Timer setting within a
range from 6 to 11 minutes.
(Energy